9
English
in Logical Channel numbering (LCN). This means that it is operator
dened which channel will be stored on position 1 and so on. Sorting
of channels afterwards is not possible. If you like to sort the channels
yourself, set the region to Other. The selection Other will store channels in
the found order.
Subtitle: Select On to display subtitles per default, select O to hide subtitles per
default.*
Aspect Mode: Use this option to select the aspect ratio of the connected TV. The options
are: 4:3 for a 4:3 TV (black bars on top and bottom of picture) and 16:9
for 16:9 TV sets.
Scan mode: Select All to store scrambled and free-to-air channels or select Free to
store only free-to-air channels.
Connection: Use this option to select the established connection to your TV set. Select
HDMI or TV SCART.
* Availability of DVB/HoH subtitles depends on the broadcast. If subtitles are not supported, they can be activated
via Teletext if available.
NOTE: Wrong region selection can lead to missing channels or channels
being stored at wrong positions in the channel list. Scrambled
channels cannot be viewed with this model.
When all settings have been made, press the GREEN Next button to continue.
Aerial Adjustment
This part of the wizard is of great help when setting up your antenna system.
Use pq to move the highlight to the setting you wish to change and use t u to change
values. The following settings are available:
Antenna Power: Set to On if you use an active antenna (with built-in amplier). When set
to On, 5 V will be present at the ANT IN connector of the receiver. Select
O for passive antennas.
Channel No.: Select a channel that is known to carry a broadcast signal in your region.
The Signal Strength and Signal Quality bars give a visual indication of the
reception. Adjust your antenna to obtain maximum signal strength and
quality.
When all settings have been made, press the GREEN Next button to start scanning.
The receiver will search for all available channels. When the scan is nished, the receiver
switches to viewing mode. Now you can enjoy watching your favourite TV channels. If you
get the message “No channels found”, then check again the antenna, coaxial cable, connector
and in menu if you have reception. When this has been checked, reset the unit and follow the
installation wizard again as shown below.
To Next Page
Loading...
