13
Equipment and Adjustments
When the stop switch cap is pulled o, the engine will stop running. e
vehicle will continue to roll for some distance, however. Remember this
when judging when to operate the remote engine stop switch.
If you do not put your fingers through the loop in the lanyard, it may slip
from your grasp unexpectedly. is could make it impossible for you to
stop the engine in an unsafe situation.
e throttle limiter should always be set to the low power position when
the engine stop lanyard is used. Only children.
With enough skill for safe operation of the ATV without parental use of the
lanyard should be permitted to operate ATV with the throttle limiter set to
maximum power position. In addition. an adult trying to follow a moving
ATV with the throttle limiter set to maximum position may run in into
the rider if he stops, or may trip and fall down trying to keep up with the
vehicle.
Instruction for engine stop switch lanyard storage. e lanyard may
be stowed on the AT\/ when, in judgment of the parents, the rider has
developed sufficient skills to be able to safely operate the vehicle without
parental use of the lanyard.
To prevent unauthorized starting or unsupervised operation of the ATV,
remove the stop switch cap and lanyard aer each use and store then in a
safe place, out oi reach of children
To Next Page
Loading...