Thump ATV110CC - Tire Inspection and Warnings

36
Inspection and Maintenance
3. Turn the recoil adjuster counterclockwise by a half turn and puil
the starter grip slowly to see if the ratchet engages and engine can
be cranked. If the recoil starter counterclockwise by another half turn,
Repeat this procedure until the starter ratchet mechanism begins to
engage.
4. Aer locating the point where the starter ratchet begins to engage,
turn the recoil adjuster counterclockwise 1 1/2 more turns and secure it
by tightening the adjuster lick nut.
5. Check again to make sure that the recoil starter ratchet engages aer
the adjuster lock nut has been tightened.
TIRES
Using tires of a dierent size or type than the tires originally equipped on
your ATV can change the ATV’s handing characteristics. Dierent handing
characteristics can result from dierences in carcass construction , sidewall
strength, thread pattern, etc.
For the riders safety, check your vehicle’s tires before each use of the vehi-
cle, to make sure they have proper pressure, enough thread depth, and no
damage.
Operating the vehicle with excessively worn tires can cause skidding due
to decreased traction. It is recommended that the front and rear tires be
replaced when the depth of the tire thread is 4mm (0.16in) or less.