40
Inspection and Maintenance
Some lubricants which are sold as drive chain lubricant can damage “O”
rings of your vehicles chain. Sue the recommended motor oil or a lubricant
that is especially intended for use on “O” ring chains.
Failure to inspect the drive chain slack before each use of the ATV could
be hazardous. Too much chain slack could cause the chain to come o the
sprockets, resulting in an accident or serious damage to the ATV.
Inspect the drive chain slack before each use.
FRONT AND REAR WHEEL REMOVAL
1. Place the vehicle on level ground and set the parking brake.
2. Loosen the three wheel nuts on the wheel to be removed.
3. Li up the front or rear end of the vehicle by placing a jack or block
under the axle or frame.
4. Remove the three wheel nuts.
5. Remove the wheel. Reinstall the wheel, reverse these steps
When replacing a wheel, it is very imponant that the wheel nuts be torqued
to the proper specications. If they are not, the wheel can come o unex-
pectedly‘ We strongly recommends that you have these nuts checked and
torqued, if necessary, by your authorized dealer.
To Next Page
Loading...