THUNDER LASER NOVA-51
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com No.197, Hudong Road, Shatian Town,
Tel :(86)769 826653 Dongguan, Guangdong, China
Introduction
This manual has been designated as the thunder laser systems, laser cutting
machine installation and user guide；The manual is divided into five chapters，
Including general information instructions, safety instructions, the key
components of every laser cutting systems and the installation steps, operation
instructions and maintenance instructions from THUNDERLASER Company.
Frist, it should be emphasized that the installation of each system must meet
the requirements, and make it consistent with the installation requirements of
THUNDERLASER. If not, the machine will not working properly，poor performance，
life shortened，maintenance costs increased and even machine damage .
The note is for getting a specific requirement of system installation，and we
hope every customer try to understand these notes before installation and usage,
thus you can correctly install and use. If you meet any installation problems，
you can contact our technical staff and customer service staff.（At the same time,
you can also refer to the machine installation video that we posted on youtube.
The specific URL is
http://www.thunderlaser.com/how-to-use-your-laser-machine/how-to-setup-your-nova-las
er-cutter.html Or
https://www.youtube.com/watch?v=NpLo1L0NQx8&list=PLjSZrgjcrhs7QucNN-3jx7rZapDGfj
G-5 .）
To Next Page
Loading...