THUNDER LASER NOVA-51
www.thunderlaser.com DONGGUAN THUNDER LASER EQUIPMENT CO.,LTD
tech@thunderlaser.com No.197, Hudong Road, Shatian Town,
Tel :(86)769 826653 Dongguan, Guangdong, China
8. Please check the water cooling system is working properly; the water is running into
and filling the laser tube. Please do not start your work if the laser tube isn’t full of
water, because that may led to laser tube damage due to the high temperature.
9. Finally press the “Start-Pause” button in the display, to start the engraving process.
10. While the laser is engraving, you can generate the next graphic.
11. When the engraving is complete, the laser machine will give out the notification sound
and the laser head will go back to the original point, and the warning light will return to
the green light, then you can repeat engraving.
To Next Page
Loading...