13
You can set the maximum
temperature at which the
charger should allow battery
to reach during charge.
Once a battery reaches
this temperature during
charge, the process will be
terminated to protect the
battery.
The battery is on the
cyclic process of charge
and discharge can often
become warm after charge
or discharge period. The
program can insert a time
delay to occur after each
charge and discharge process to allow the battery
adequate time to cool down before being subjected
to the next process. The value ranges from 1 to 60
minutes.
Temp. Cut-off
ON 80C
Display
Display
- +
DEC INC
- +
DEC INC
Waste time
CHG/DCHG 5min
Display
- +
DEC INC
- +
DEC INC
Display
DEC INC
DEC INC
To Next Page
Loading...
Need help?
General
