26
TigerStop
®
Standard Controller Basic Functions
prog raM Mi n g a puS Her or SeT po inT li ST
1. Start at the Ready Screen.
2. Press the [Show] soft key.
3. Press the [List] soft key.
4. Enter the list number to program and then press the [Edit] soft key.
• Choose a number between 1 - 100.
5. Select the [Pusher] or [Setpoint] soft keys.
6. Dynamic Optimization upgrade, only: Press to optimize the list for
maximum material yield. Otherwise, press
7. Pusher List, only: Press to use a global or press to use a local
head & tail cut.
Global - Uses the head & tail cut setting from the Part List menu.
Local - Set a head and tail cut that is used for this list, only.
• Head & tail cuts are trim cuts at the ends of the material.
8. Enter the length of the part to process and press
9. Enter how many parts to process at that length, followed by
To Next Page