8
6.1 Connecting devices to create a Seliro full mesh network
6.1.1 Your router support Seliro full mesh
Connect a first IHD103 to the router using the Wi-Fi WPS connection procedure. The same
procedure is then used for additional IHD103 that should be a part of the mesh network. For
each new IHD103 that should be connected, the pairing procedure is done between the
router and the new IHD103 to connect. When later placing all IHD103 in their final position in
the home, they will organize and connect to each other in the most suitable way.
6.1.2 Your router does not support Seliro full mesh
Connect a first IHD103 to the router using the Ethernet cable connection procedure.
Additional IHD103 are connected using the Wi-Fi WPS connection procedure.
Note that the Wi-Fi WPS connection procedure for a new IHD103 should always be used
between the first IHD103 (connected via Ethernet cable to the router) and the new IHD103.
When later placing all IHD103 in their final position in the home, they will organize and
connect to each other in the most suitable way.
6.2 Connecting devices to create an extender network
The Wi-Fi extender can only connect wirelessly to a 5 GHz Wi-Fi radio on the router.
Support for 5 GHz radio on the router is normally indicated by statements such as,
concurrent dual band Wi-Fi, 802.11a, 802.11ac or 802.11ax.
6.2.1 Your router supports 5 GHz Wi-Fi
Use the WPS pairing procedure to establish a Wi-Fi connection between the router and the
IHD103. The Ethernet cable connection procedure is available as well.
6.2.2 Your router does not support 5GHz Wi-Fi
Use the Ethernet cable connection procedure to establish a wired connection between the
router and your extender.
6.3 Connect using the Ethernet cable procedure
1) Connect the Ethernet cable to one of the LAN Ethernet interfaces of your router.
To identify the Ethernet LAN interface of your router, consult the installation guide that
comes with the router. A router typically has four Ethernet LAN outlets, all marked with the
same color marking.
2) Connect the other end of the Ethernet cable to the WAN interface (#4) of the IHD103
It is the connector closest to the power connector.
3) Plug in the AC/DC power adapter that comes with the device to the power connector (#5)
of the device.
4) Plug in the other end of the power adaptor to a wall outlet.
5) The network connection status LED will be lit (RED) after a short while.
6) Once the device has connected properly both LED’s will turn stable GREEN
To Next Page
Loading...