9
6.4 Connect using the Wi-Fi WPS procedure
1) Plug in the power adapter that comes with the IHD103 to the power connector (#5) of the
device.
2) Plug in the other end of the power adaptor to a wall outlet.
3) The network connection status LED will be lit (RED) after a short while.
4) Both LEDs will turn RED and flash slowly when the device is ready, this will take up to 2
minutes.
5) Locate the WPS button on your router and press it.
6) Locate the WPS button on your new IHD103 and press it. The Wi-Fi status LED will start
flashing rapid green.
7) The two devices will establish a connection over Wi-Fi.
8) Connection is established once the Wi-Fi extender Wi-Fi LED turns stable GREEN.
6.5 Connect using the local GUI procedure
Configure the IHD103 from the local GUI is suitable if you want to make more major changes
of the device, such as switching between the extender and the Seliro full mesh mode. It can
also be used for the connection procedure, but the most suitable way is to use the Ethernet
or WPS procedure. In some cases, it is necessary for Wi-Fi extender configuration.
1) Plug in the AC/DC power adapter that comes with the device to the power connector (#5)
of the device.
2) Plug in the other end of the power adaptor to a wall outlet.
3) The network connection status LED will be lit (RED) after a short while.
4) Both LEDs will turn RED and flash slowly when the device is ready, this will take up to 2
minutes.
5) Connect the device to the router using either the WPS or the Ethernet cable procedure.
6) Access the local GUI of the device following the procedure described
7) Perform the wanted connection configuration.
To Next Page
Loading...