TiLite ZRA - Securing the Occupant; Positioning the Restraint Belts

14-10
ZRA_Aero Z Owner’s Manual
OM_ZRA_Aero Z_0913RevA
CHAPTER 14: TRANSPoRTATioN oPTioNS
Figure 14-5
Tie-Down Brackets
Aero Z (Aluminum Frame)
Back View
Front View
Tie-Down
Brackets
Tie-Down
Brackets
Figure 14-6
6. Carefully inspect each of the four tie-down brackets to ensure that they are properly secured to the
wheelchair.
7. Carefully inspect each wheelchair tie-down strap for damage or wear.
8. The four wheelchair tie-down straps must be attached to the four tie-down brackets in accordance
with the WTORS manufacturer’s instructions and SAE J2249.
9. Each of the four wheelchair tie-down straps must be tightened to ensure that the wheelchair is
securely fastened to the vehicle—there should be no “play” or looseness in any of the four wheelchair
tie-down straps.
SECURING THE OCCUPANT; POSITIONING THE RESTRAINT BELTS
IWARNING
A three-point, vehicle-anchored, pelvic and upper torso belt occupant restraint system must be
properly installed and used to restrain the occupant while riding in your TiLite Aero Z (Titanium
Frame) or ZRA wheelchair in a motor vehicle.
IWARNING
A three-point, occupant restraint system, consisting of either a wheelchair-anchored or a vehicle-
anchored pelvic belt and a vehicle-anchored upper torso belt, must be properly installed and used
to restrain the occupant while riding in a TiLite Aero Z (Aluminum Frame) wheelchair in a motor
vehicle.