13-3
ZRA_Aero Z Owner’s Manual
OM_ZRA_Aero Z_0913RevA
CHAPTER 13: ANTI-TIPS
Adjusting
To adjust the height of the User-Friendly Anti-Tip, press the two release buttons on the telescoping lower tube and
adjust the height of the lower tube so that the wheel is within 1-1/2” to 2” off the ground. See Figure 13-5.
Figure 13-5
Adjusting the Anti-Tip
Anti-Tip
Mount
Release Button
Receiver
Upper Tube
Lower Tube
Release Button
Removing
To remove the User-Friendly Anti-Tip tube, press the two release buttons in the anti-tip receiver and pull the upper
tube out of the anti-tip receiver. See Figure 13-5.
Mounting
I
WARNING
Only an authorized TiLite dealer or qualied technician should install the anti-tip receiver.
If you ignore this Warning,
you may fall, tip over or lose control of the wheelchair and seriously injure yourself or others or damage the
wheelchair.
IWARNING
Do not disassemble the anti-tip mounting assembly. See Figure 13-6.
If you ignore this Warning, you may fall, tip
over or lose control of the wheelchair and seriously injure yourself or others or damage the wheelchair.
Tools Needed:
• 5/32” Allen Wrench
• 3/16” Allen Wrench
• 5/64” Allen Wrench
1. Remove the rear wheels and place the frame upside down on a level surface.
2. Remove the camber tube. See “Replacing the Camber Tube” on page 8-2.
3. Thread the Allen screw through the right side camber tube clamp and into the right side anti-tip mount using the
center of the three threaded holes and loosely tighten. See Figures 13-6.
4. Repeat Step 3 with the left side camber tube clamp and the left side anti-tip mount.
5. Reinstall the camber tube. See “Replacing the Camber Tube” on page 8-2. The bumper cannot be reinstalled.
6. With the wheelchair standing upright on a level surface, engage the anti-tip as described under “Engaging” on
page 13-2.
To Next Page
Loading...
