8-4
ZRA_Aero Z Owner’s Manual
OM_ZRA_Aero Z_0913RevA
CHAPTER 8: AXLE PLATES AND CAMBER PLUGS
(CENTER OF GRAVITY; REAR SEAT HEIGHT)
6. Measuring from the oor at the rear of each tire, mark the tire (with a felt tip pen) at the same height as
Measurement A.
7. Measuring from the oor at the front of each tire, mark the tire (with a felt tip pen) at the same height as
Measurement A.
8. Measure the distance between the left and right tires at the rear reference marks made in Step 6. See Figure 8-6.
9. Measure the distance between the left and right tires at the front reference marks made in Step 7.
10. If the measurements in Steps 8 and 9 are the same (within 1/8”), no toeing adjustment is needed, and you may
skip to Step 13. If not, proceed to Step 11.
11. Loosen the Allen screw in each camber clamp that secures the camber tube in place.
12. If the measurement in Step 9 is less than the measurement in Step 8, rotate the camber tube using the 7/8” Open
End wrench rearward to toe-out the rear wheels. If the measurement in Step 9 is greater than the measurement
in Step 8, rotate the camber tube using the 7/8” Open End wrench forward to toe-in the rear wheels. Continue
adjusting the camber tube until these two measurements are equal. See Figure 8-7.
13. Securely tighten the Allen screws in the camber tube mount.
14. Square the casters to the oor.
Figure 8-6
Adjusting the Toe-In/Toe-Out
Toe-In/Toe-Out
Measurement
Wrench
Figure 8-7
Adjusting the Toe-In/Toe-Out
Camber Plug
Camber
Tube
To Next Page
Loading...
