TimerGPS TimerGPS+ - Battery Charging and Maintenance; Charging the Battery

27
8.5.5 Exercise Autostart -function
When the Autostart-function is enabled the driver can set a time of how long TimerGPS+ waits until the exercise will start
automatically. If the Autostart-feature is enable the timer will ask minutes and seconds for the Autostart-function every time
before the exercise is started. Use UP- and DOWN keys to select Minutes or Seconds and use START/STOP key to select it.
Using UP- and DOWN keys you can adjust minutes and seconds to whatever you desire and once finished use START/STOP
key again to confirm your selection. When ready, select “Ready” and press START/STOP key to start exercise. You can toggle
Autostart function on and off from the Exercise options. Go to Settings > Exercise options > Exercise autostart. Autostart
function is enabled when you can see ►-symbol in front of the Autostart -word. Select the Autostart -word and press
START/STOP button to toggle feature on and off.
9 Charging the battery
To recharge the product use the charger adapter and USB-cable included in the product package. Remove the adapter from the
plastic packaging and cast the packaging aside. Take the USB cable and plug the USB head into the corresponding slot on the
adapter. Carefully open the protection cap on the bottom of the product and turn out. Next plug the other end of the USB cable
into the now revealed slot on the product. Plug the plug into a power outlet. The product should now show an escalating bar next
to the BAT icon on the bottom left of the display showing its charging status. When the battery is fully charged, the bars in the
BAT icon will remain solid.
*PLEASE NOTE! Do not charge the product below +10℃ (50℉) or over +30℃ (86℉).
10 Maintenance
When not using the product, store it in a dry place at room temperature. Do not store within wet, moist or any kind of non-