PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-36 161
Parameters: ON - The <DELETE> ($7F) key is used for editing your typing.
OFF - The <BACKSPACE> ($08) key is used for editing your typing.
Use the DELETE command to select the key to use for deleting while editing.
Set DELETE OFF (default) if you wish to use the <Backspace> key to edit typing mistakes. Set DE-
LETE ON if you wish to use the <Delete> key to edit mistakes.
See the BKONDEL command controls how the PK-232 indicates deletion.
DFrom all,none,yes/no call1[,call2..]Default: all
Mode: Packet Host: DF
Parameters: call - all, none, YES list, NO list.
list of up to eight call signs, separated by commas.
DFROM determines how your PK-232 responds to stations trying to use your station as a digipeat-
er. DFROM is set to "all" when you first start your PK-232. Type DFROM to display the
ALL/NONE/YES_list/NO_list status of station's call signs whose packets will or will not be repeated.
To prevent all stations from digipeating through your station, type DFROM NONE.
To permit one or more specific stations to digipeat through your station, type DFROM YES (fol-
lowed by a list of calls signs). Packets will be digipeated only from stations whose call signs are
listed.
To prevent one or more specific stations to digipeat through your station, type DFROM NO (fol-
lowed by a list of call signs). Packets will not be digipeated from stations whose call signs are
listed.
Clear DFROM with %, & or OFF as arguments.
DIDdle: ON|OFF Default: OFF
Mode: Baudot, ASCII Host: DD
Parameters: ON - In Baudot, the PK-232 will send the LTRS character when idling.
In ASCII, the PK-232 sends the NULL (00) character.
OFF - No characters are sent when idling in transmit.
In the RTTY modes, it may be desirable to continue sending some data while paused at the key-
board. With DIDDLE on, the PK-232 will send idle characters when waiting for keyboard entry.
Disconne Immediate Command
Mode: Packet Host: DI
DISCONNE is an immediate command that initiates a disconnect command to the distant station to
which you are connected. If your disconnect command is successful, your monitor will display:
*** DISCONNECTED: (call sign)
Other commands can be entered while a disconnect is in progress. New connections are not al-
lowed until the disconnect is completed.
To Next Page
Loading...