PK-232 – MBX OPERATING MANUAL COMMAND SUMMARY
4/91 A-44 169
HEAderln ON|OFF Default: ON
Mode: Packet Host: HD
Parameters: ON - The header in a monitored packet is printed on a separate line from the text.
OFF - The header and text of monitored packets are printed on the same line.
When HEADERLN is ON (default), the address is shown, followed by a <CR><LF> that puts the
packet text on a separate line as shown below:
WX1AAA>WX2BBB:
Go ahead and transfer the file.
HEADERLN affects the display of monitored packets. When HEADERLN is OFF, the address informa-
tion is shown on the same line as the packet text as shown below:
WX1AAA>WX2BBB: Go ahead and transfer the file.
Help Immediate Command
Mode: Command Host: Not Supported
While in Command Mode, type the command "H" to read the abbreviated on-line HELP file. Your
monitor displays the following brief list:
Help:
AMtor PAcket AScii
ARq Connect BAudot
AList Disconne MOrse
FEc MHeard DISPlay
AChg CStatus CALibrat
NAvtex SIgnal FAx
TDm CONVerse Trans
Xmit Rcve Lock
RESTART RESET
MDCheck TClear
You can enter Command Mode at any time to list the HELP text.
HEReis "n" Default: $02 <CTRL-B>
Mode: Baudot, ASCII and AMTOR Host: HR
Parameters: "n" - Is the hex representation ($01-$7F) of the character that causes the AAB
string to be sent in the middle of transmitted text.
If you wish to send your own AAB string for identification during a transmission simply enter the
HEREIS character (default <CTRL-B>). Also see the command AAB.
HId ON|OFF Default: OFF
Mode: Packet Host: HI
Parameters: ON - Your PK-232 sends HDLC identification as a digipeater.
OFF - Your PK-232 does not send HDLC identification.
Set HID ON to force your PK-232 to send an ID packet every 9.5 minutes when it's being used as a
digipeater. Otherwise leave HID OFF (default).
To Next Page
Loading...