PK-232 MBX – OPERATING MANUAL COMMAND LIST
F-4 230
COMMAND DEFAULT FUNCTION
OK Immediate Command Transfers to mode after Signal Identification
Opmode Immediate Command Displays current PK-232 operating mode
PAcket Immediate Command Starts the Packet Mode
PACLen 128 Sets the number user data bytes in a packet
PACTime AFTER 10 Sets the Packet automatic transmit timer
PACTor Immediate Command Enters the Pactor mode (PT for short)
PARity 3 (even) Sets the terminal vrogram parity (0-3)
PASs $16 <CTRL-V> Sets the converse mode pass character
PASSAll OFF Ignores CRC in receiving packets (Junk mode)
PErsist 63 Sets the P-persistent CSMA threshold
PPersist 014 Selects P-persistent CSMA operation
PRCon OFF Enables a parallel printer you have connected
PPFax ON Prints received PAX to parallel printer
PRout OFF Sends all received data to parallel printer
PRType 2 (Epson) Sets the graphics emulation for FAX printing
PT200 ON Allows 200 bauds for Pactor if link is good
PTConn Immediate Command Starts a Pactor connect with (CALLSIGN)
PTHuff 0 Selects Pactor data compression (0 = OFF)
PTList Immediate Command Starts the Pactor Listen mode
PTOver $1A <CTRL-Z> Sets the Pactor link direction change character
PTSend Immediate Command Starts the Pactor unproto send mode (call CQ)
RWWhdlc OFF Starts Raw HDLC mode
RBaud 45 bauds (60 WPM) Sets the Baudot RTTY baud rate selection
Rcve Immediate Command Selects the receive mode Morse/RTTY/AMTOR
RECeive $04 <CTRL-D> Selects the Receive character used in text
REDispla $12 <CTRL-R> Re-displays current terminal input buffer
RELink OFF Re-connects after link fails due to retries
RESET Immediate Command RESETs PK-232 and bbRAM to factory defaults
RESptime 0 Sets the minimum delay before sending an ACK
RESTART Immediate Command Restarts PK-232, same as turning power off/on
REtry 10 Sets the maximum number of packet repeats
RFec ON Receives FEC in AMTOR Standby
RFRame OFF Checks RTTY characters for framing errors
RXRev OFF Reverses the received data mark-space sense
SAmple Immediate Command Enters the raw data sampling mode
SELfec Immediate Command Starts a selective FEC call with SELCAL
SEndpac $OD <CTRL-M> Sets the converse mode "Send packet" character
Slgnal Immediate Command Starts the Signal Identification mode
SLottime 30 Sets the P-persistent CSMA slot time
SQuelch OFF Sets the receiver squelch carrier polarity
SRXall OFF Allows reception of ALL received SELFEC calls
STart $11 <CTRL-Q> Sets character to start sending terminal data
STOp $13 <CTRL-S> Sets character to stop sendina terminal data
TBaud 1200 bauds Sets the ASCII terminal data rate
TClear Immediate Command Clears the transmit Buffer (Non-Packet modes)
TDBaud 96 Sets the receive data rate for TDM signals
TDChan 0 Sets the receive channel for TDM signals
TDm Immediate Command Enters the TDM receive mode
TIme S14 <CTRL-T> Inserts the time (in DAYTIME) in text
TMail OFF Enables AMTOR and Pactor Maildrop
To Next Page
Loading...