PK-232 MBX – OPERATING MANUAL COMMAND LIST
F-5 231
COMMAND DEFAULT FUNCTION
TMPrompt (see text) Sets an 80 character AMTOR Maildrop Message
TRACe OFF Enables a Hex dump of received data
Trans Immediate Command Enters the Transparent data mode
TRFlow OFF Enables software flow control RX in Trans.
TRIes 0 (zero) Displays or forces packet retry counter
TXDelay 30 Sets the PTT key-to-data delay (×10 ris)
TXFlow OFF Enables software flow control TX in Trans.
TXrev OFF Reverses transmitted mark-space data sense
UBit 0 Controls seldom used ON/OFF commands
UCmd 0 Controls seldom used numeric commands
Unproto CQ Sets the UI packet frame sending Path/address
USers 1 Sets allowed number of packet multi-connects
USOs OFF Sets RTTY 'unshift on space'
VHF ON Selects VHF Packet - wide (1000 Hz) shift
WHYnot OFF Displays reason why packet not displayed
WIdeshft OFF Selects RTTY- wide or narrow (200 Hz) shift
Wordout OFF Sets Word output in RTTY/AMTOR/Pactor modes
WRu OFF Enables auto-answerback (AAB) in RTTY/ASCII
XBaud 0 Sets 8530 baud rate to receive Baudot/ASCII
XFlow ON Sets Software (XON/XOFF) RS-232 flow control
Xmit Immediate Command Starts sending Baudot/Morse/FAX transmission
XMITOk ON Allows transmitter PTT line to be keyed
XOff $13 <CTRL-S> Sets character to stop sending received data
XON $11 <CTRL-Q> Sets character to start sending received data
ZFree Immediate Command Returns number of blocks of available memory
ZStatus Immediate Command Returns status of several internal parameters
To Previous Page
Loading...