Tippmann X7 PHENOM - Cylinder Safety and Removal

12
E
N
G
L
I
S
H
Programming Navigation
(Electro-pneumatic model)
Entering Programming - Unload the marker (page 10) and remove the air/CO2 supply
(page 14). Never attempt to do Advanced Programming on a pressurized marker!
Put the Selector Switch in Safe mode (page 6). Press and hold the Programming Button and
move the Selector Switch to the FA mode. After 2 seconds, the LED turns solid red. Release
the Programming Button. You are now in the main programming menu. Cycle through the
menu items using trigger pulls.
Cycling through the menu - To cycle through the menu items, pull and release the trigger.
Each time the trigger is pulled and released, a different color code is displayed by the LED as
listed in Advanced Programming on page 11.
Enter a menu option - Once the LED displays the color code of the desired menu item, pull
and hold the trigger for two seconds.
Current Value - Upon entering a menu item, the LED begins ashing red. The ashes
represent the current menu value. The current value is ashed twice with a short pause
between the value ashes. If a new value is not entered before the end of the second value
ash display, the electronics automatically return to the main menu.
Enter a new value - Any time while the LED is ashing with its current value, a new value
can be entered by pulling and releasing the trigger. Each pull and release of the trigger counts
as 1 when entering the new value. For example, to enter a number 5, pull and release the
trigger ve times.
Successfully updated menu conrmation - Once you enter a new value for a menu
item, the LED ashes red/orange/green twice to signify an acceptable value has been
entered. The electronics then returns to the main menu. If an unacceptable value is entered,
the LED quickly ashes red, and returns to the main menu. The value of the menu item
remains unchanged if this happens.
Power Off - After a menu item has been changed, you must power-off the electronics before
the change takes effect. Move the Selector Switch to Safe mode (S) or Mechanical mode (F),
and the electronics power down. Move the Selector Switch back to the FA position to power
up the electronics and use the new settings.
Optional Factory Settings Reset - You can reset programming back to the Factory
Default Settings. Move the Selector Switch to the FA position. Press and hold the
programming button for 10 seconds. Release the Programming Button and the LED ashes
red/orange/green twice. The electronics power down for 10 seconds and then power back up.
All settings are reset to factory defaults at this point.
Air/CO2 Cylinder Warnings
Refer to Figure 9. There have been reported incidents caused by players unknowingly
unscrewing the cylinder (2) from the cylinder valve (1). This occurs when the player thinks the
entire valve-cylinder assembly is being unscrewed from the air/CO2 adapter of the paintball
marker, when in fact he or she is unscrewing the cylinder from the cylinder valve.
To avoid this danger, it is recommended (if your cylinder is not already marked) that you use
paint or nail polish to place a mark (3) on the cylinder valve, and place another mark (4) on the
cylinder, in line with the #3 mark as shown in Figure 9.
WARNING
The brass or nickel plated cylinder valve (Figure 9, #1) is intended to
be permanently attached to the air or CO2 cylinder (2).
An air or CO2 cylinder can y off with enough force to cause serious
injury or death if the cylinder (2) unscrews from a cylinder valve (1).