TKH TKID45F2S - Enhance Image

User Manual - Network Dome - TKID45F2S - TKID85F2S - TKID45M1S - TKID85M1S
EN
27
Table 2-7 DNR parameters description
Parameter Meaning Configuration Method
2D NR Reduce noise of image.
[Configuration method]
Select from the drop-down list
[Default value]
Auto
3D NR Reduce noise of image.
[Configuration method]
Select from the drop-down list
[Default value]
Auto
Max Strength
It is valid in auto noise filter mode.
When the parameter value is 0, the
noise filter is disabled. When the
parameter value is greater than 0, the
noise filter is enabled, and the system
automatically adjusts the noise filter
level based on the ambient brightness
without exceeding the value of this
parameter.
[Setting method]
Drag the slider.
[Default value]
50
Fixed Strength
It is valid in a manual noise filter
mode.
[Setting method]
Drag the slider.
[Default value]
50
2.9 Enhance Image
Figure 2-13 shows the enhance image interface and Table 2-8 shows the enhance image
parameter.