71
PRE-OPERATION CHECKS
(R2 type)
(R3 type)
Water Separator
Water separator is located near by the
engine cover fixing lever of the boat
side. Check the water separator for
water accumulation. Clean it or
consult with an authorized
TOHATSU outboard motor dealer for
cleaning (see page 145).
Battery
Battery handling differs according
to the type of the battery and the
instructions described below might
not be applicable to the battery of
your outboard. Refer to the battery
manufacturer’s instructions.
Battery Inspection
Check whether the battery fluid is
between the upper and lower levels,
and check the vent hole in the battery
caps for clogging.
If the battery fluid is near or below
the lower level, add the distilled
water to the upper level (see page
141).
Check that the battery cables are
connected securely.
If the battery terminals are
contaminated or corroded, remove
the battery and clean the terminals
(see page 142).
CONTROL LEVER
FRICTION ADJUSTER
To decrease
friction
To incre a se
friction
CONTROL LEVER
FRICTION ADJUSTER
To decrease
friction
To incre a se
friction
36ZZ0T030_EN.book Page 71 Tuesday, November 28, 2017 4:19 PM
To Next Page
