TOHATSU BFT 90A - OPERATION; Break-in Procedure

93
STARTING THE ENGINE
10. Turn the engine switch key to the
ON position.
The propeller must be lowered into
the water, running the outboard
motor out of the water will damage
the water pump and overheat the
engine.
11. Pull the emergency starter rope
lightly until resistance is felt, then
pull briskly.
If the engine fails to start refer to
Troubleshooting page 161.
Exposed moving parts can cause
injury. Use extreme care when
installing the engine cover. Do not
operate the outboard motor
without the engine cover.
(H1 type)
ON
ENGINE SWITCH KEY
(H2 type)
ENGINE
SWITCH
KEY
ON
ON
(R1 type)
ON
ENGINE
SWITCH KEY
(R2, R3 types)
ENGINE
SWITCH KEY
ON
36ZZ0T030_EN.book Page 93 Tuesday, November 28, 2017 4:19 PM