ENGINE OPERATION 27
5
3
Releasing the shallow water setting
a.Turn the Reverse Lock Lever upward to
set them in "LOCK" position.
b.Tilt up the engine slightly and then let it
go down. The shallow water setting is
then released.
c.The engine is released from shallow
water setting, and locked at normal
running position.
Do not shift into Reverse during planning,
or control will be lost leading to serious
personal injury, boat may swamp, and/or
hull may be damaged.
Do not shift into Reverse during cruis-
ing, or control may be lost, falling down
or causing passenger(s) to be thrown
overboard. Leading to serious personal
injury, and steering system and/or shift-
ing mechanism may be damaged.
Never stop the engine immediately after a
full throttle run. Keep it running for two or
three minutes at idling speed (Shift Lever
set to Neutral) to allow it to cool down.
F type
1
Reduce the engine speed to idling rpm.
2
Keep pressing on the Stop Switch or
pull out the lock plate/ The engine will
then stop.
5. Stopping the engine
MWX50D2_E.book Page 27 Thursday, August 18, 2011 5:29 PM
To Next Page
Loading...
