REMOVING AND CARRYING THE OUTBOARD MOTOR32
6
1
Stop the engine.
2
Disconnect the fuel connector, the
remote control cables, the battery
cords, bracket fixing bolts and nuts etc.
3
Remove the outboard motor from the
hull and completely drain the water from
the gear case.
Do not carry the outboard motor immedi-
ately after stopping engine when they are
so hot that they burn hands if touched.
Be sure to keep the engine vertical whenever
you carry the outboard motor.
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak,
potentially catching fire.
When carrying or putting the engine up for
storage, make sure the side with the elec-
tric motor of the Power Trim and Tilt is
down otherwise air will enter the pump
system for the Power Trim and Tilt opera-
tion.
1. Removing the outboard motor
2. Carrying the outboard motor
REMOVING AND CARRYING THE OUTBOARD MOTOR
MWX50D2_E.book Page 32 Thursday, August 18, 2011 5:29 PM
To Next Page
Loading...
