EasyManua.ls Logo

TOHATSU MX 50D2 - Trim Angle

TOHATSU MX 50D2
178 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENGINE OPERATION28
5
Notes
After stopping the engine, close the air
vent screw on the tank cap.
Disconnect the fuel connector of the
engine or the fuel tank.
Disconnect the cables from the battery if
the engine will not be used for an
extended period of time.
3
Disconnect the fuel connector from the
engine.
Never fill up portable fuel tanks on board to
avoid fire or explosion resulting from
spilled gasoline. If gasoline is ever spilled
on board, wipe it up thoroughly. Fuel tanks
must always be filled up on land.
4
Close the air vent screw on the fuel tank
cap.
The following instructions explain how to
set the best trim angle of the boat.
F type
The trim angle is adjusted by setting the
thrust rod in the correct thrust rod hole.
Proper trim angle
The trim angle is optimum when the boat
is parallel to the water surface while run-
ning.
Improper trim angle (bow rises too
high)
If the trim angle is excessive, the bow will
rise out of the water and the speed will
decrease.
Furthermore, the bow may sway or the
bottom may slam the water while cruising.
CAUTION
Air vent screw
6. Trim angle
Perpendicular to the
water surface
MWX50D2_E.book Page 28 Thursday, August 18, 2011 5:29 PM

Table of Contents

Other manuals for TOHATSU MX 50D2

Related product manuals