Tohnichi CTA2-G - Production Tightening Mode

35
Production tightening mode
1. Setting items
Setting items Display
Default
Alternative selection
1 Tightening mode ＳＥＬ MODE-S、MODE-P
2 Measurement Unit USEL N・m
kgf・cm/kgf・m/lbf・
in/lbf・ft
3 Tightening torque SE
0
Below max torque
4
Tightening torque upper
limit
SE_Ｈ
0
Below max torque
5 Snug torque Ｓｎｇ
0
Below max torque
6 1
st
tightening angle Ａｎ１
0
Bellow 999
7
1
st
tightening angle upper
limit
Ａ１_Ｈ
0
Below 999
8 2
nd
tightening angle Ａｎ２
0
Below 999
9
2
nd
tightening angle upper
limit
Ａ２_Ｈ
0
Below 999
10 3
rd
tightening angle Ａｎ３
0
Below 999
11
3
rd
tightening angle upper
limit
Ａ３_Ｈ
0
Below 999
12 Spindle number ｎ
1
Below 999
13 NG setting ｎｇ
NG_RES
AL_RES
14 Tightening direction ｔＵｒｎ
CW
CCW
15 Auto memory/reset timer Ａｒ
0.0
0.0, 0.1 - 5.0
16 Buzzer ｂＵ
ON
OFF
17 Auto power off timer ＰｏＦＦ
3min
10min, 30min, NONE
18 External output mode ｄｏ
PC
PRN
19 Baud rate ｂｐＳ
9600
2400, 4800, 19200
20 Data length ｄＬ
8bit
8bit
21 Parity Ｐｒｔ
Even
None，Odd
22 Default ｄＦＬｔ
DFLT-N
DFLT-Y
23 Time (h/m/s) ｒｔＣ１
None
―――
24 Date (y/m/d) ｒｔＣ２
None
―――
* Default function (21) does not initialize the tightening mode and time and date.
* Single Spindle Tightening mode setting (P28）
* For setting though the application software (PC), refer to the instruction manual enclosed
inside the application CD.