Component Technical Manual Crypto VGA
Document Ref 942179-001 Rev 1 Page 6-9
Issue A
14) Fit new battery pack into the bracket.
15) Re-fit the bracket and battery pack into the unit and re-fit and tighten the two screws to
secure in position.
16) Plug in the spades onto the new battery pack.
17) Plug in all the connections on the Crypto VGA unit.
18) Place the Crypto VGA unit back into the unit and secure in position by tightening the
wing nut.
19) Place the printer assembly back into the unit on its drawer runners.
20) Plug in all connections on the printer unit.
21) Close the Crypto VGA printer drawer to reset alarm.
22) Return the relevant Crypto VGA to Normal mode at the POS.
23) Check operation of the new battery.
To Next Page
Loading...