About taking photos
You can use your TomTom Bandit to take photos in the following modes:
Normal - A single photo is taken.
Burst - A series of photos are taken in a very short time.
You can select the mode using the control button on the TomTom Bandit, or you can use the Mobile
app.
Each photo mode has its own range of settings.
Photo Mode Summary
Photos are saved in JPEG format.
Taking single photos
You can take a photo either directly from the TomTom Bandit, or by using the remote control, or
from the Mobile app.
To take single photos, select NORMAL mode, either directly on the TomTom Bandit or from the
Mobile app.
Note: If your TomTom Bandit is connected to the Mobile app, you can only use the app to change
TomTom Bandit settings.
Take a photo using only the TomTom Bandit or the remote control
1. Select NORMAL photo settings on the TomTom Bandit.
2. Press the START button on the TomTom Bandit or remote control.
The TomTom Bandit beeps and the red LEDs flash to show that a photo is being taken.
The TomTom Bandit beeps again when the photo is saved.
The TomTom Bandit screen shows the number of photos taken.
Tip: Move right on the TomTom Bandit screen to see the time remaining that you can video or
how many photos you can take. The time remaining depends on the space available on the
microSD card, and the photo mode you are using.
3. Edit and upload your photos using the Mobile app.
Take a photo using the Mobile app
1. Connect the Mobile app to your TomTom Bandit.
2. Select Single photo on the Mobile app.
3. Press the START button on the TomTom Bandit or the record button in the Mobile app.
To Next Page
Loading...
Need help?
General