Using the remote control to record a movie
To wake up the remote control, press the START button (button 2) for 3 seconds until the LED (3)
flashes green two times.
Press the START button (button 2) to start recording. The LED (3) flashes red when the camera is
recording.
Press the START button (button 2) to add a highlight to your video.
Press the STOP button (button 1) to stop recording. The LED (3) stops flashing.
Remote control straps and mounts
The remote control wrist strap fits over a bare wrist. The strap extension can be used to make the
wrist strap longer so it fits over the arm of a winter coat, for example during snow sports. The
straps can also be used to secure the remote control to a handle bar, a selfie stick, or any suitable
location.
Note: The remote control is splash-proof and should not be submerged in water.
Changing the battery in the remote control
The remote control uses a button cell CR2032 battery.
To change the battery do the following:
1. Using a coin, turn the battery cover anticlockwise a small amount until it unlocks, then remove
it.
2. Gently lever out the battery cell.
3. Replace the battery with a new one.
4. Install the cover turn it clockwise with a coin until it locks.
Using lens covers
The standard lens cover is splash-proof (IPX7). If you want to use the TomTom Bandit in water or
underwater to depths down to 50 m, or for activities on the water surface, for example surfing,
install the optional waterproof (IPX8) lens cover.
Note: When using the IPX8 lens cover, the microphone and barometer are concealed and will not
work with this lens cover.
To Next Page
Loading...
Need help?
General