TomTom Bandit User Manual

7
Charging your TomTom Bandit
You can charge your TomTom Bandit in the following two ways:
Charging the Batt-Stick using a USB socket
Important: If you remove the Batt-Stick or lens cover be extra careful not to let dirt or water enter
the TomTom Bandit or the Batt-Stick. Only remove the Batt-Stick or lens cover in clean and dry
conditions.
1. Press the Batt-Stick release button, then turn the Batt-Stick anticlockwise and pull it out of the
TomTom Bandit.
2. Insert the Batt-Stick USB connector into your computer's USB socket or a standard USB
wall-charger.
Tip: While the Batt-Stick is charging, the LEDs show the charge level and one LED flashes.
3. To see the power level of the Batt-Stick, remove the USB connector from the USB charging
socket, then press the START button.
The LEDs light up to show the power level.
TomTom Bandit Quick Start

TomTom Bandit Specifications

General

Photo Resolution	16 MP
Sensor	CMOS
Battery	1900 mAh
Battery Life	Up to 3 hours
GPS	Yes
Resolution	4K
Image Sensor Size	1/2.3-inch
Field of View	160°
Storage	MicroSD card (up to 128GB)
Connectivity	Wi-Fi, Bluetooth
Sensors	Accelerometer, Gyroscope
Dimensions	94 x 38 x 52 mm
Weight	190 grams
Frame Rate	30fps (4K), 60fps (1080p), 120fps (720p)
Waterproof	IPX7 (without additional housing), IP68 with optional lens cover