TomTom Bandit User Manual

65
The Mobile app will not start until you have connected your smartphone to your TomTom Bandit
using Wi-Fi.
Tip: For iOS only. If your smartphone is Bluetooth Smart (BLE) capable, Wi-Fi is switched on and
off automatically by the Mobile app. Wi-Fi is also switched off when it isn't used for a while.
Follow these steps to connect your TomTom Bandit to your smartphone, and start the Mobile app:
1. Switch on your TomTom Bandit.
2. From the Camera Status screen, move up to turn on the TomTom Bandit's Wi-Fi connection.
The name of the Wi-Fi connection and the password are shown on the screen.
3. On your smartphone, go to the phone's Wi-Fi settings screen then select the TomTom Bandit
Wi-Fi connection from the network list.
4. Enter the password shown on the TomTom Bandit screen.
Your phone connects to the TomTom Bandit. On the TomTom Bandit, the screen shows Con-
nected to device.
5. Start the Mobile app.
The Mobile app starts and shows the Viewfinder screen.
Connecting to the Mobile app

TomTom Bandit Specifications

General

Photo Resolution	16 MP
Sensor	CMOS
Battery	1900 mAh
Battery Life	Up to 3 hours
GPS	Yes
Resolution	4K
Image Sensor Size	1/2.3-inch
Field of View	160°
Storage	MicroSD card (up to 128GB)
Connectivity	Wi-Fi, Bluetooth
Sensors	Accelerometer, Gyroscope
Dimensions	94 x 38 x 52 mm
Weight	190 grams
Frame Rate	30fps (4K), 60fps (1080p), 120fps (720p)
Waterproof	IPX7 (without additional housing), IP68 with optional lens cover