TomTom Go 520 User Manual

30
The arrival information panel shows the following information:
 The estimated time that you will arrive at your destination.
 The length of time to drive to the destination from your current
location.
 A parking button is shown near the destination flag when parking is
available near your destination.
Tip: If your destination is in a different time zone, you see a plus
(+) or a minus (-) sign and the time difference in hours and half
hours in the arrival information panel. The estimated time of arrival
is the local time at your destination.
If you have stops on your route, select this panel to change between
information about the next stop and your final destination.
You can choose the information you see on the arrival information panel.
Traffic status - if your GO isn't receiving any traffic information, a
symbol showing traffic with a cross appears underneath the arrival
information panel.
The bar uses symbols to show the following information:
 The next two stops on your route.
Tip: To quickly remove a stop, select it in the route bar and use the
menu.
 Petrol stations that are directly on your route.
 TomTom Traffic including heavy rain or snow.
 TomTom Speed Cameras and Danger Zones.
 Rest stops directly on your route.
You can choose the information you see on your route.
The symbols are in the order that they occur on your route. For traffic
incidents, the symbol for each incident alternates between showing the
type of incident and the delay in minutes. Select a symbol to see more
information about a stop, an incident or a speed camera. If a symbol is
shown on top of another symbol, selecting the symbols zooms in on the
route bar to show each symbol separately. You can then select a symbol.
The total time delay due to traffic jams, weather, and other incidents on
your route, including information provided by IQ Routes, is shown above
the symbols.
For a complete list of incident types, see Traffic incidents.
The bottom of the route bar represents your current location and shows
the distance to the next incident on your route. In addition, you can
choose to see the current time if you switch the setting on.
Note: To make the route bar more readable some incidents may not be shown. These incidents
will always be of minor importance and only cause short delays.
The route bar also shows status messages, for example Finding fastest route or Playing route
preview.
Looking at traffic on the map
Traffic incidents are shown on the map. If several traffic incidents overlap the highest priority
incident is shown - for example, a road closure is higher priority than road works or a closed lane.

TomTom Go 520 Specifications

General

Outdoor (hiking, trekking)	Yes
Marine (chartplotters, sounders)	No
Internal memory	64 MB
Storage capacity	512 MB
Display resolution	480 x 272 pixels
Display size (HxV) (imperial)	4.3 \
Processor frequency	400 MHz
Battery life (max)	5 h

Weight and Dimensions

Depth	24 mm
Width	118 mm
Height	83 mm
Weight	220 g