Tone Commander 8610 - Transferring Calls; Conferencing Calls

Tone Commander 8610/8620 User Guide 9
Transferring Calls
Use this feature to transfer an active call to another party.
Press the
TRAN key while in an active call.
The current call is placed on hold, and an idle call appearance
is automatically selected. The
TRAN indicator flashes (on
some network switch types, the CONF indicator may light
instead of the TRAN indicator).
Dial the party you want to transfer the call to with the dial pad
or a Speed Dial key.
Wait until the called party answers to announce the call, or
transfer it immediately before the called party answers.
Press the
TRAN key again to complete the transfer.
DSS Transfer
While on an active call, press the TRAN key.
Press the DSS key for the destination party.
Press the
TRAN key to complete the transfer.
Conferencing Calls
You can initiate multi-party conference calls. Conferences are limited to
3 or 6 parties, depending on your network configuration.
Conferencing a New Call
Press the CONF key while on an active call.
The current call is placed on hold and an idle call appearance
is automatically selected. The
CONF indicator lights.
Dial the party you wish to add to the conference.
After the added party answers, press the
CONF key to
conference all parties together.
Repeat the above steps to add another party.