Topcon 3D-MC2 - Table of Contents

Table of Contents
P/N 7010-0921
I
Table of Contents
3D-MC² ................................................................... 1-1
3D-MC² Components ...................................................... 1-1
3D-MC² Dozer Schematic ......................................... 1-2
3D-MC² Introduction ....................................................... 1-3
Setup and Usage .................................................. 1-11
Project Files ..................................................................... 1-11
Importing Project Files ....................................... 1-11
Creating a Project File ........................................ 1-13
Exporting Project Files ....................................... 1-14
Control Point Files ........................................................... 1-19
Importing Control Point Files ............................. 1-19
Layers .............................................................................. 1-22
Importing Layers ................................................ 1-22
Surface and Alignment Files ........................................... 1-25
Surface File Types .............................................. 1-25
Importing Surface Files ...................................... 1-26
Selecting an Active Surface File ........................ 1-28
Using an Alignment File as a Reference ......................... 1-29
Selecting an Active Alignment File .................... 1-30
Creating a Machine Configuration File ........................... 1-31
Setting Blade Control ...................................................... 1-37
Automatic Best-Fit Blade Control ...................... 1-37
Control Using Single Point on Blade ................. 1-38
Valve Offset Calibration .................................................. 1-40
Configuring Radios .......................................................... 1-42
Performing Topographic Surveys .................................... 1-46
Using Supervisor Mode ................................................... 1-48
Changing the Password ...................................... 1-50
Locking Menus, Buttons and Screen Items ........ 1-51
Releasing All Locks ............................................ 1-55