Blade Response
P/N 7010-0921
A-23
Blade Response
This section lists possible Blade Response problems
you may encounter. If you still have problems after
trying the solutions listed here, contact TPS customer
support.
Problem
Blade is moving too slowly. The blade seems to move
too slowly in Control Mode. The Grade Indicator
takes too long to reach grade.
Causes Solutions
The Valve Gain
setting is too low.
Increase the Valve Gain setting,
which will cause the hydraulics
to respond quicker.
Check which control is slow
before adjusting the Valve Gain.
Remember that the larger
number setting speeds up the
response.
To Next Page
Loading...
