Home
Topcon
Construction Equipment
3D-MC2
Page 79 (Changing the 3 D View)
Topcon 3D-MC2 - Changing the 3 D View
128 pages
Manual
Save Page as PDF
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
Changing the Display View
P/N 7010-0921
1-73
Changing the 3D View
1.
W
ith 3D acti
ve, press an
d hold the 3D screen for
one second, to display the 3D options menu.
2.
Press
Camera
Foc
us
Po
in
t
s
, and choose the
focus point of the camera.
78
80
Table of Contents
Main Page
Table of Contents
5
3D-MC²
7
3D-MC² Components
7
3D-MC² Dozer Schematic
8
3D-MC² Introduction
9
Setup and Usage
17
Project Files
17
Importing Project Files
17
Creating a Project File
19
Exporting Project Files
20
Control Point Files
25
Importing Control Point Files
25
Layers
28
Importing Layers
28
Surface and Alignment Files
31
Surface File Types
31
Importing Surface Files
32
Selecting an Active Surface File
34
Using an Alignment File as a Reference
35
Selecting an Active Alignment File
36
Creating a Machine Configuration File
37
Setting Blade Control
43
Automatic Best-Fit Blade Control
43
Control Using Single Point on Blade
44
Valve Offset Calibration
46
Configuring Radios
48
Performing Topographic Surveys
52
Using Supervisor Mode
54
Changing the Password
56
Locking Menus, Buttons and Screen Items
57
Releasing All Locks
61
Viewing GPS Information
62
Steering or Grading to Polyline
66
Adjusting Valve Gain
69
Changing Cut/Fill Offsets
71
Changing the Cut/Fill Offsets Using the Elevation Control Key
71
Changing the Cut/Fill Offsets Using the Set-Points Pop-Up Menu
72
Changing the Display View
75
Main Window Views
76
Left Window Views
77
Right Window View
77
Lower Window Views
78
Changing the 3D View
79
Changing Display Options
85
Direction of Travel Options
86
Working Surface and Alignment Display Options
87
Changing the Background Color
89
Display Units Options
90
Viewing and Updating 3DMC
91
Changing 3DMC Options
91
Troubleshooting
95
Base Station
96
GX-60 Display
100
MC-R3 Controller/Receiver
108
MC² Sensor
112
GPS Localization
112
Blade Response
117
Safety Information
119
General Precautions
119
Radio Usage Information
121
General Usage Warnings
122
Base Station Precautions
123
Internal Battery Pack Warnings
124
Other manuals for Topcon 3D-MC2
Installation And Calibration Manual
32 pages
To Next Page
