Topcon 3D-MC2 - Changing the Cut;Fill Offsets Using the Set-Points Pop-Up Menu

Setup and Usage
3D-MC² Quick Reference Guide
1-66
2. Change the offset using the up/down arrows, or
press the numeric field to access the keyboard, and
press Ok.
Changing the Cut/Fill Offsets Using the
Set-Points Pop-Up Menu
The Set-points pop-up menu allows quick adjustment
of the cut/fill offsets from the Main Screen.
1. To access, press and hold anywhere on the Main
Screen.
2. Press Set-pointsEnabled (left) or Enabled
(Right) to display the set-point (cut/fill offsets)
adjustment arrows. Enable the set-point arrows
above the Elevation Control Key. Pressing the keys
above the Slope Control Key has no effect.