3.4 White Board Luminance Factor
The white board luminance factor is displayed.
Display Method
☞
「3.1.2 Data/Setting Item Display」
Change Procedure
☞
「3.1.3 Numerical Value Setting」
3.5 White Board Correction Factor
The white board correction factor is displayed. If the correction factor has not been registered,
"REF NO DATA" is displayed.
Display Method
☞
「3.1.2 Data/Setting Item Display」
The input/change method is the same as the input/change method for the correction factor.
☞
「3.6.２ Inputting the Correction Factor」
・ It is possible to set just one white board correction factor.
To Next Page
Loading...
