3.10 Buzzer Sound
The setting for whether or not to set a buzzer sound is displayed.
Display Method
☞
「3.1.2 Data/Setting Item Display」
The procedure for setting the buzzer is as described below.
1
Press the [CHANGE] button.
2
Press the [ROTATION] button and select the setting contents.
Each time the button is pressed, the buzzer is turned ON/OFF.
3
After selection is finished, press the [ENTER] button.
3.11 Communication Format
The communication format with the PC is displayed.
Display Method
☞
「3.1.2 Data/Setting Item Display」
The communication format consists of BM-7A Series and BM-7FAST.
・ BM-7FAST is a communication format for the purpose of using communication software for
old model BM-7 and BM-7fast. The commands for BM-7AC is increased than the BM-7
and BM-7fast, so when creating new communication software, the BM-7A Series mode is
recommended.
The procedure for selection the mode is as described below.
1
Press the [CHANGE] button.
2
Press the [ROTATION] button and select the setting contents.
Each time the button is pressed, the display will change as shown below.
BM-7A Series → BM-7FAST → BM-7A Series ……
3
After selection is finished, press the [ENTER] button.
To Next Page
Loading...
