Topcon CropSpec AGA5408 - Default Chapter; Table of Contents

x
Table of contents
Chapter 1 – Introduction 1
Chapter 2 – Installing CropSpec Hardware 3
2.1. 1014172-01 Gen 3 Lite harness connections 5
2.2. AGA4700 harness connections 6
Chapter 3 – CropSpec Setup 7
3.1. Enabling Universal Terminal 7
3.2. Enabling CropSpec feature 8
3.3. Setting up the sensors 9
3.4. Setting output configuration 14
3.5. Histogram view 16
3.5.1. Starting and stopping data collection 17
Chapter 4 – CropSpec Operation 19
4.1. Recording CropSpec readings 19
4.1.1. Exporting CropSpec job reports 21
4.2. CropSpec prescription types 24
4.2.1. On/Off 24
4.2.2. Two Point 24
4.2.3. One Point plus Slope 24
4.2.4. Target Rate 24
4.3. Configuring prescription types 25
4.3.1. Creating a new prescription 25
4.3.2. Configuring On/Off prescription 27
4.3.3. Configuring Two Point prescription 28
4.3.4. Configuring One Point plus Slope prescription 29
4.3.5. Configuring Target Rate prescription 31
4.4. Configuring Japanese wheat prescription types 34
4.4.1. Configuring Yousui prescription 34
4.4.2. Configuring Tomeba East prescription 35
4.4.3. Configuring Tomeba North prescription 36
4.5. Managing prescriptions 39
4.5.1. Selecting a prescription 39
4.5.2. Transferring prescriptions to and from USB 39
4.5.3. Deleting prescriptions 40