Topcon IS-100 - Page 14

OPHTHALMIC UNIT
IS-100
Rev. 6 - November 2019Rev. 6 - November 2019
2-1
USER MANUAL
2. GENERAL
2.1. SAFETY
For the correct and safe use of the unit, it is necessary to identify the hazards
theunitmighthave,aswellasobservethesafetymeasuresdenedbytheuser:
y Installation and handling of the products of TOPCON/ANCAR should be
carried out by authorised personnel. In particular, electrical connections
mustbecarriedoutonlybyqualiedspecialists.
y It is forbidden to perform any replacement or remove protective caps.
y Do not attempt to repair any material after a fault or damage and put it back
into operation again. In these cases, it is essential to contact TOPCON’s
ocialdealer.
y No liability can be accepted for damage caused as a result of a misuse.
y Store or install the unit in a controlled environment the conditions of which
conformtothespecicationbelow:
 Temperature: 10 ºC - 40 ºC
 Moisture: 30% - 75%
 Atmospheric pressure: 700 hPa - 1060 hPa
 Free from condensation and dust.
 Not exposed to direct sunlight.
y In the event of an anomalous situation, disconnect the unit immediately and
consult the technical support team.
y The unit must be installed in a place where it can be easily disconnected.
y Place the instruments centred on the tabletop, and if possible, fastened to
it. Do not use them to move the tabletop.