Can not get a network connection
Ë Make sure you are using a Router and not a Modem.
Ë You can only establish a connection by using the Net-
work cable directly to the Toppro unit.
Ë Your router settings are not set up correctly in the Top-
pro.
Ë The router is not switched on.
Ë Check connection of Ethernet cable, making sure they
are a tight
t in the socket.
Ë Re start Router and try again.
Ë You are not using a T
d USB wireless dongle.
Can not connect my external HDD
Ë Make sure external HDD is formatted in NTFS, then re-
formatted to the system when it is connected. This will
ensure that the hard drive is ready to use and the full
capacity is available.
Ë The HDD must not be more then 1000 GB (1 TB)
Ë You must make sure that the external HDD is self pow-
ered
Can not get the time to show on the front of the Toppro
The Toppro is designed to save powe
r when in standby mode
as per the Australian MEPS standard. This reduces power con-
sumption to less then 1W when in STAND BY. This can be ad-
justed in the Settings e Miscellaneous e Standby Mode, from
Passive to Active.
I am unable to get out of the MENU
Ë With all Toppro product you are unable to exit from
the MENU unless channels have been tuned in to the
recorder.
Ë Check the antenna connection.
A7
A. Troubleshooting 81
To Next Page
Loading...
