Introduction
All you have to do is set up the remote control to work with
your particular equipment. Please read this guide carefully to
make sure the setup is done properly and that you are getting
the most out of your remote control.
Switching the TV to/ from Stand-by.
Changing TV channels via the number buttons.
Volume Control Function.
Multimedia Control Function.
-
-
-
-
-
Installation
The remote control runs on 2 x AAA batteries.
To insert or replace the batteries, follow these steps;
Set up
If your TV is made by Philips then your remote control is
settings, as follows:
When you're using the remote control, make sure:
Push the catch on the battery cover upwards and pull the
Carefully remove the old batteries (if applicable) then insert
the new batteries, matching the + and – signs.
Once the batteries are in, put the cover back on, making
sure the cover clicks into place.
1)
2)
3)
There's nothing blocking the infrared receiver on the PVR
box (or TV).
-
-
84 B. Universal Remote Control
To Next Page
Loading...
