Tornado 99328 - Vacuum Motor; Wheels

18
MAINTENANCE
Draining Solution Tank:
1. Locate drain hose at front of unit and position over
acceptable floor drain or container.
2.Turn valve handle to open drain valve.
3.Return valve handle to closed position. Tuck drain
hose back on machine.
Flush and clean tanks after each use and allow to air
dry to eliminate odors and corrosion of vacuum motor.
Vacuum Motor
To service vacuum motor which is located above re-
covery tank:
1. Disconnect vacuum hose clamp.
2. Remove four screws.
3. Disconnect wires and remove cover.
4. Remove vacuum motor to service.
Wheels
Machines are equipped with either ‘foam-filled” or hard
urethane tires. No service is required.