Tornatech GFD - Page 15

15
Click on the “Go to Setup” button. The “Config” page is now visible. Click on the “padlock” button to log in with your
password. If needed, read the “User Login / KeyPad” section for more information on how to enter your password.
Once a valid password is confirmed, the “Config” page will be visible again with the “padlock” showing that it is open
the actual user security level.
Select the controller pressure units, cut-in and cut-out. Verify that all other parameters on the setup page are
correct.
Once the configuration is done, click on the “Home” membrane button. The “First Setup” page will be displayed