- PT fault detected: If an optional dual pressure sensor is installed, it will be activated if the two pressure
transducers show different readings. Further investigation is advised to determine what caused the different
readings. Note that the controller will always choose the lowest pressure reading to determine the actual system
pressure. Also, if the voltage powering the transducer is below 0.5V or over 4.5V the alarm will be activated.
- Overpressure: Activates if the analog readout of the discharge pressure goes higher than the overpressure set
point in the discharge pressure sensor page.
- Underpressure: Activates if the analog readout of the discharge pressure goes lower than the “Under Pressure”
set point in the discharge pressure sensor page.
- Low Suction Pressure: Activates if the analog readout of the suction pressure is Enabled and goes lower than the
low suction pressure set point in the suction pressure sensor page.
- Force start on flow: Activates if an external contact triggers flow switch input or if the analog readout of the flow is
Enabled and goes higher than the flow force start on flow set point in the flow sensor page.
- Water Res. Low: Activates if the “Water Reservoir Low” contact input is triggered or if the analog readout of the
water reservoir is Enabled and is lower than the water reservoir low set point in the “Water Level” sensor page.
- Water Res. Empty: Activates if an external contact triggers the optional “Water Reservoir Empty” input.
- Main Relief Valve Open: Activates if an external contact triggers the optional “Main Relief Valve Open” input.
- Fuel Tank Leak: Activates if the “Fuel Tank Leak” contact input is triggered,
- Low Fuel Level: Activates if the “Low Fuel Level” contact input is triggered or if the analog readout of the fuel level
is Enabled and goes lower than the low fuel level set point in the “Fuel Level” sensor page.
- High Fuel Level: Activates if the “High Fuel Level” contact input is triggered or if the analog readout of the fuel
level is Enabled and goes higher than the high fuel level set point in the “Fuel Level” sensor page.
- Engine Fail When Running: Activates if the “Engine Run” signal is lost while the engine is running. The engine will
try to start the cranking sequence once again if the starting causes are not back to normal.
- Engine Fail to Start: Activates if the engine fail to start after the complete 6 attempts crank sequence. The engine
will turn red.
- Engine ECM: Activates if the specific “ECM” input is triggered on the engine connector strip.
- Engine ECM Warning: Activates if the specific “ECM” input is triggered on the engine connector strip.
- Engine ECM Fault: Activates if the specific “ECM” input is triggered on the engine connector strip.
- Engine FIM: Activates if the specific “FIM” input is triggered on the engine connector strip.
- Engine PLD Low Suction Pressure: Activates if the specific “305” input is triggered on the engine connector strip.
- Engine High Raw Water Temperature: Activates if the specific “310” input is triggered on the engine connector
strip.
- Engine Low Raw Water Flow: Activates if the specific “311” input is triggered on the engine connector strip.
- Engine High Temperature: Activates if the specific “High Temp” input is triggered on the engine connector strip
and the engine is running. A 3 hour timer will start when the engine stops, and if the condition is still present, the
alarm will be activated. This alarm will stop the engine only if triggered during a manual run test or a weekly test.
- Engine Low Temperature: Activates if the specific “Low Temp” input (312) is triggered on the engine connector
strip.
To Next Page
Loading...
Need help?
General
