Tornatech GPD - Starter Configuration; Sensor Selection

34
Charger boost health monitor enable: If checked, this feature will enable the monitoring of the chargers boost
health.
Charger boost health test interval: This is the minimum interval between two charger boost tests.
Charger boost detection threshold: This is the minimum value the voltage has to raise during a boost test for the
test to be consider as a success.
Starter Configuration
Config > Advanced > Starter Configuration
This page displays information on the charger configuration. If more than one starter is installed, it will be possible
to choose which starter will be activated first.
Cranking Time: Duration of a cranking step.
Rest between cranking: Durantion of the pauses between two cranking steps.
Cranking Steps: Number of times the controller will activate the starter.
Sensor Selection
Config > Advanced > Sensors
Important Notice!
Every analog sensor cable used for this controller should be shielded. The shield has to be grounded on the motor
side. Not complying to these recommendations may affect the controller good functioning and void its warranty.