Toro 03676 - Jacking Point Locations; Lubrication; Greasing the Bearings and Bushings

JackingPointLocations
Note:Supportthemachinewithjackstands
wheneveryouworkunderthemachine;referto
Specications(page28).
Usethefollowingasmachine-liftpoints:
g375763
Figure67
1.Frontofthemachine
3.Rear-axletube
2.Jackbrackets(front-axle
tube)
4.Backofthemachine
•Front—thejackbracketsofthefront-axletube
(Figure67).
•Rear—therear-axletube.
Lubrication
GreasingtheBearingsand
Bushings
ServiceInterval:Every50hours(andimmediately
aftereverywashing).
GreaseSpecication:No.2lithiumgrease
1.Preparethemachineformaintenance;referto
PreparingforMaintenance(page41).
2.Openthehood;refertoOpeningtheHood(page
41).
3.Thelubricatethemachineatthettingsatthe
locationsasfollows:
•Pump-driveshaftU-joint(3)(Figure68)
Note:Thepump-driveshaftislocatedUnder
thehood.
g003962
Figure68
•Cutting-unitlift-armcylinders(2each)
(Figure69)
g012150
Figure69
43