Greensmaster Flex 21Page 7 – 8Cutting Unit (Rev. C)
Factor Possible Problem/Correction
Stability of bedbar. Make sure bedbar pivot bolts are securely seated.
See Bedbar in Service and Repairs section.
Number of reel blades. Use correct number of blades for clip frequency and
optimum height–of–cut range.
Rear roller level. Reel and rear roller should be parallel for proper
cutting performance.
See Leveling Rear Roller in Adjustments section.
Rear roller position. The rear roller position is determined by the
height–of–cut.
See Rear Roller Height Adjustment in Adjustments
section.
Roller condition. Make sure rollers rotate freely. Repair bearings as
necessary.
See Roller Bearing Replacement in Service and
Repairs section.
Traction speed. Check maximum governed engine speed. Adjust
engine to specifications if necessary. The drive belts
may be loose or worn. Check the condition of the belts
and adjust or replace as necessary.
See Adjustments section in Chapter 3 – Engine and
Chapter 4 – Traction and Reel Drive System. Also, see
Service and Repairs section in Chapter 4.
Groomer reel operation. See Troubleshooting section of Chapter 8 – Groomer
(Model 04201) or Chapter 9 – Groomer (Model 04204).
To Next Page
Loading...
Need help?
General
