Why is the drive weak on my Toro Lawn Mower?
If the drive of your Toro Lawn Mower feels weak, several factors could be responsible. The PERSONAL PACE® torsion spring might be overwound; in this case, remove and reinstall it with the correct wrap. A worn belt or pulley can also cause this issue, so consider replacing them. Lastly, check if the traction cable spring is disconnected and, if so, install the traction cable end to the transmission.
How to fix Toro 21472 Lawn Mower wheels falling off?
If the wheels are falling off your Toro Lawn Mower, the wheel bolt threads or the pivot arm threads may be damaged, requiring replacement. Also, make sure that you apply thread locker to the wheel bolt threads and tighten the wheel bolt to the correct torque.
Why does the Toro 21472 Lawn Mower handle pull too far back?
If the handle of your Toro Lawn Mower pulls too far backwards towards the operator, it may be due to missing PERSONAL PACE® handle pins. Disassemble the PERSONAL PACE® handle and install the handle pins.
What to do if there is delayed engagement in Toro 21472 drive?
If there is a delayed engagement in the drive of your Toro Lawn Mower, it may be because the PERSONAL PACE® handle pins are missing. To resolve this, disassemble the PERSONAL PACE® handle and install the handle pins.
General| Brand | Toro |
|---|---|
| Model | 21472 |
| Category | Lawn Mower |
| Power Source | Gasoline |
| Deck Material | Steel |
| Mulching Capability | Yes |
| Bagging Capability | Yes |
| Side Discharge Capability | Yes |
| Starter Type | Recoil |
| Type | Walk-Behind |
| Engine | Briggs & Stratton |
| Cutting Width | 22 inches |
| Drive System | Self-Propelled |
| Cutting Height | 1.0 to 4.0 inches |
| Weight | 80 lbs |
| Fuel Tank Capacity | 0.25 gallons |
| Oil Capacity | 20 oz |
| Wheel Size | Front: 8 in (20.3 cm) |
Details DANGER, WARNING, CAUTION symbols and general safety precautions.
Covers specific safety advice like avoiding unexpected starting, lacerations, burns, fires, and using proper PPE.
Provides detailed technical specifications for different mower models.
Lists recommended fastener torque values for various thread sizes and grades.
Outlines common problems and their possible causes and corrective actions.
Provides step-by-step instructions for removing and installing the engine or powerhead.
Details the removal and installation procedures for the brake cable.
Outlines the steps for removing and installing the RWD traction cable.
Provides instructions for replacing the AWD front traction cable.
Details the process for removing and installing the AWD rear traction cable.
Covers the replacement procedure for the RWD PERSONAL PACE® handle assembly.
To Next Page